Worked guide / 02 · Measured batch
Check a measured water change
Your tank notes use US gallons, but your jug is marked in liters. Compare them in the same unit before you calculate a percentage.
A Freshwater Setup worked example. The volumes are illustrative.
1. Mark which number is which
The aquarium holds 14 US gallons at its starting waterline, after accounting for displacement. The jug shows 8 L for the measured batch. Use the graduated mark you actually reached rather than the capacity printed on the jug.
2. Put both numbers in liters
Multiply 14 US gal by 3.785411784 L per gallon, the factor listed by NIST. That’s roughly 53.00 L. Divide the 8 L batch by the unrounded starting volume, then multiply by 100: 15.10%. Before refilling, 45.00 L (11.89 US gal) remains.
Dividing 8 by 14 would give about 57%, because it silently treats the 8 L as 8 gallons. Two US gallons would be about 7.57 L, which would represent 14.29% of the starting volume in this example.
3. Write down the units next to the mark
A useful entry is “8 L measured batch · about 2.11 US gal · 15.10% of 14 US gal starting water.” Record the starting waterline too. If the tank begins below that line another day, the same jug amount represents a different share of the water actually present.
This compares amounts; it does not set a schedule or account for an existing deficit below the intended refill line.
